The ipod Touch utilizes a touch-delicate display as the interface for gaming as nicely as as productivity and other apps. A broken touch display should be eliminated and changed with a touch display screen bought in opposition to an ipod components shop if the Touch is to carry on becoming utilized to its complete abilities. You can eliminate the touch display screen versus a initial-generation ipod Touch your self, even although it is a bit much more challenging than the 2nd-generation design which changed it. The process only demands a couple of minutes and some typical hardware resources, but you need to be ready to void the Apple guarantee.
Points You are going to Will need
- Soft cloth Putty knife Phillips jeweler's screwdriver Flat-edged jeweler's screwdriver
Put the soft cloth on a table. Put the ipod Touch face up on the soft cloth.
Insert the putty knife into the seam among the touch display screen and the bezel just previously mentioned the "Residence" button. Wiggle the putty knife across the bottom to loosen the clips. Repeat this method, loosening the touch display screen by inserting the putty knife into the left and proper sides and then the best of the touch display, amongst it and the bezel adjoining it.
Get rid of the back again cover against the ipod Touch. Set the back again cover apart. Set the front of the ipod Touch down on the soft cloth with the battery pack going through up.
Scrape the putty knife versus all of the sides of the battery to loosen the glue keeping it to the ipod Touch. Take away the battery pack and Put it down meticulously on the soft cloth so that the connection in between it and the motherboard is not severed.
Peel off the black tape versus the bottom of the ipod.
Use the Phillips jeweler's screwdriver to get rid of the a few screws that have been below the black tape.
Use the Phillips screwdriver to take away the screw concealed underneath the wire linked to the motherboard that is connected to the battery pack.
Insert the putty knife amongst the metal plate that was held down by the screws and the front of the ipod Touch. Wiggle the putty knife to dislodge the metal plate. Take away the metal plate.
Use the Phillips jeweler's screwdriver to get rid of the two screws against the other finish of the front of the ipod Touch.
Use the flat-edged screwdriver to release the two cables against the bottom left of the front of the ipod Touch.
Insert the flat-edged screwdriver in between the circuit board at the bottom exactly where the cables and screws ended up and the front of the ipod Touch. Wiggle the screwdriver to release the circuit board. Get rid of the circuit board.
Pull back again the cables and the motherboard to reveal the touch display below them. Use the Phillips screwdriver to get rid of all of the screws versus the sides of the front of the ipod Touch.
Insert the flat-edged screwdriver in between the touch display and the front of the ipod Touch. Wiggle the screwdriver to loosen the touch display screen. Get rid of the touch display.
No comments:
Post a Comment